New boats & used boats for sale - search our large selection of boats from around the world

2010 Wellcraft 247 Fisherman

$40,000 USD

  • $40,000 USD
  • Default User
  • Active
  • Used
  • Center Consoles
  • 2010
  • Wellcraft
  • 247 Fisherman
  • Vero Beach, Florida, US
  • Power
  • 25ft / 7.62 m
  • Suzuki
  • Df300
  • Outboard 4 Stroke
  • Unleaded
  • Fiberglass
  • 2016-10-03
  • 2016-10-03
  • 2307949

FOR QUESTIONS CONTACT: STEVE 239-634-3904 or (e-mail us using the link on this page)

1985 Wellcraft 247 Fisherman (Completely restored in 2010)

-Boat- Hull sides from rub-rail to chines-removed all nicks, scratches, etc. from original gel-coat, prepped, then repainted with Imron Paint- 9/1/16 (Americraft Enterprises, Daytona Beach).
-Motor- 100hr Service and inspection, replaced Scuppers, re-torque bolts to spec on Bracket (International Marine, Boynton Beach, Fl.)- 5/12/16
-Trailer- Replaced all Calipers with new Kodiaks, New 6-Lug Kodiak Silvercad Slipovers, new -Heavy Duty Winch Strap, New jack, New 24in Brake Line and Brake Fluid, 4 new tires.(Meltra Trailers, Ft. Pierce, Fl)-4/26/16

-New Custom T-Top built with E-Tech Retractable Outriggers added
-Added LED Spreader Lights
-Added LED over-head console light bar (Red, white)
-Replaced running lights with LED lights
-Custom Sunbrella Boat Cover, covers motor and swim platform. Added additional skirt to cover below the chines (sides). (Sunnyland Canvas, Ft. Pierce, Fl.)

-Replace and Raise Transom with Full Height Top-Cap
-Design and Install Transom Door in Transom, exits on to Armstrong Bracket
-Install New Armstrong 72in Wide-Body Bracket with Ladder Mount
-Box-In Fuel Filter and Raw-Water Wash-Down Pump Compartment for easy access
-Re-Locate Scuppers to Transom VS. Sides of Hull
-Added Port and Starboard Bent Butt Rod Holders
-Added Electric Plugs on Port and Starboard and 50Amp Breakers
-Added Undergunnel LED Lights (Scarab Chris, THT)
-Added new 12X12 Performance Lenco Trim Tabs W/Indicator Switches
-Filled a few little nicks in the side of hull

-Remove Black Bottom Paint from hull
-Re-Gelcoat bottom of hull to new condition/Sand and Buff

Repowered with 2008 Suzuki 300hp purchased new in box 7/09, rigged with Fly By Wire controls and digital fuel management gauge. Motor went into commission mid-2010, after all work below was completed. Only 287 Hours.

-Re-place Deck Floor, re-core all hatches and bow pulpit- Re-Gelcoat and Non-Skid all non-smooth areas
-Remove all carpeting in V-Berth, prep and gelcoat texture web finish
-Replace rotted stringers on port and starboard side of fuel-cell, aft. Laminate plywood to -bottom of fuel-cell panel.
-Imron paint smooth area of deck-cap and buff non-skid areas
-Install new rub-rail kit
-6 new Deck Access plates
-Replace V-Berth windows
-Replace Windshield
-Repair old motor holes after repower (twins to single motor)
-Remove fuel tank, inspect, clean and pressure check, install all new fuel fill and fuel hoses with USCG Ethanol compliant hoses.
-New Leaning Post/Livewell combo, cut-down and fiber-glassed into leaning post, plumbed. (Fab-Tech, Daytona Beach, Fl.)
-Removed all wood-trim, including console and v-berth doors, etc. and replaced with non-wood trim/doors. All new latches, etc.
-New Sea Star Helm
-Completely re-wired Boat and Electronics (ACM Electronics, Jacksonville, Fl.)
-Fusion IP600 Head-Unit
-(4) 8in Speakers
-JBL Marine 4-Channel Marine Amplifier
-Lowrance HDS-7 Insight USA 50/200 Transducer
-Linked new motor to Lowrance (NMEA 2000 compatible)
-Digital VHF and AM/FM Antenna
-VHF Radio
-Lowrance external GPS and WAAS Antenna
-Installed New Gunnel Bolsters and (2) Back Rest Cushions

New LoadMaster Trailer
-Overbuilt 9800# GVWR Tandem Torsion Axles
-(4) Kodiak 12in Silver Cad Plated Disc Brakes
-SS Hardware Package
-Spare Wheel/Tire Radial
-LED Side Marker Lights

BOAT LOCATION: Vero Beach, FL (32962)



For Sale By Anglers Edge Marine

298 Water Forest Dr
Dingmans Ferry, Pennsylvania, 18328